YAMAHA RHINO FRONT CV BOOT GUARDS INSTALLATION

Rhino Front CV Guard Installation Instructions
1-021
Remove product from packaging.
Hardware consists of :
• 4ea. 1/4-20 X 3/4 BHCS SS
• 4ea. 1/4-20 x 5/8 BHCS SS
• 4ea. 1/4-20 NYLOCK NUTS
• 4ea. 1-023 J-CLAMP
1. Remove O.E.M. boot guards.
2. Place new guard in position with largest side toward the front.
3. Insert ¼-20 x 3/4” bolts into two bottom holes from underneath passing through a-arm.
4. Thumb the lock nut on each bolt.
5. Place aluminum j-clamp over the front a-arm tube aligning with holes in front side of guard.
6. Thread ¼-20 x 5/8” bolts into j-clamp.
7. Tighten all bolts.
8. A third hole is provided in bottom of guard for an additional fastener if desired.
9. Enjoy!!!!!
If you have any questions, please call 423-569-3478 or visit http://www.dirtperformance.net/ , e-mail question to
producttech@dirtperformance.net.